Wireless Oom » measurement

What kind of measurements in WCDMA?

wirelessoom — Tue, 09 Feb 2010 00:44:33 +0000

There are 5 different measurements in WCDMA.

1. Signal measurement:
2. Traffic volume measurements
3. quality measurement
4. UE internal measurement
5. positioning measurement

What is the distinct difference between Cell_DCH and other states' measurements?

wirelessoom — Mon, 27 Jul 2009 06:13:54 +0000

In Cell_DCH, the UE makes measurements and reports them to the UTRAN for action by the UTRAN.

However, in other states, the measurements are not reported to the UTRAN and the UE takes action based on the measurements. (though Cell_FACH measurement has some common things with Cell_DCH)

What for SIB 11?

wirelessoom — Sun, 26 Jul 2009 19:53:22 +0000

SIB 11

contains measurement control information for a UE in idle mode.

If SIB 12 is not present it can also be used for UEs in connected mode.

When is measurement data reported ?

wirelessoom — Fri, 19 Jun 2009 23:48:36 +0000

Measurement procedures allow the UE to provide the network with different measurement reports that will be used by the radio resource management strategies.

The network configures

1. what objects to measure (e.g., the cells, transport channels, physical channels)

2. criteria to be used (e.g., periodic reporting or event-trigger)

3. RLC mode to be used (e.g., AM or UM)

This configuration is done by means of Measurement Control Message.

Measurements are required only by UEs in Cell_DCH and Cell_FACH states.

In some cases such as traffic volume monitoring, UEs in Cell_PCH may also send measurement reports. –> I think this is why power consumption during Cell_PCH is higher (around 5mA) than idle mode (around 1mA).

—————-

I found out later that even in idle, URA_PCH, measurements may be done.